Renesas User System Interface Board HS7047ECH61H Bedienungsanleitung PDF herunterladen (Seite 70)

3.4.3 Precautions on Connecting the User System

When connecting the evaluation chip board to the user system, note the followings:

1. Secure the E6000H station location.

Place the E6000H station and evaluation chip board so that the station to trace cable is not bent or twisted, as

shown below. A bent or twisted cable will impose stress on the user interface, leading to connection or

contact failure. Make sure that the E6000H station is placed in a secure position so that it does not move and

impose stress on the user interface during use.

HITACHI

E6000H

HITACHI

E6000H

2. Make sure the power supply is off.

Before connecting the evaluation chip board to the user system, check that the emulator and the user system

are turned off.

3. Connect the UVCC to the user system power.

The emulator monitors and determines whether the user system is turned on or off by the UVCC pins

(HS7046EPH60H: pins 48, 50, 52 (VCC), 54, 56, 58, 60, 62, and 64 (PVCC)) on the user system interface

connector (UCN2).

Accordingly, after connecting the user system to the emulator, be sure to supply power to the VCC pins.

Otherwise, the emulator assumes that the user system is not connected.

When the user system is connected, check that the power of the user system is supplied to these pins.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 242 243

Keine Kommentare

Renesas User System Interface Board HS7047ECH61H Bedienungsanleitung Seite 70