Renesas User System Interface Board HS7047ECH61H Bedienungsanleitung PDF herunterladen (Seite 197)

111

• Make the following settings in the group boxes on the [Address] page:

Uncheck the [Don’t Care] checkbox.

Then use the [Editor] window to refer to the address on the line that has ‘a[i]=j;’ within the tutorial

function and enter this address in the [Address] edit box. In this example, enter H'0000107C.

• Make the following settings in the boxes on the [Count] page:

Uncheck the [Don’t Care] checkbox.

Enter D’5 in the [Count] edit box.

Note: The content of this dialog box differs depending on the product. For details on each product, refer to

section 3, Debugging, or the online help.

Figure 4.37 [On Chip Break Channel 4] Dialog Box

• Click the [OK] button. Then click the [Close] button on the [Breakpoint Properties] dialog box.

The on-chip breakpoint that has been set is displayed in the [Event] window.

Note: The items that can be displayed in this window differ depending on the product. For the items that can be

displayed, refer to section 3, Debugging, or the online help.

Close the [Event] window. Then select [Reset Go] from the [Debug] menu to stop the tutorial program at on-chip

breakpoints. The program runs and then stops at the breakpoint that has been set. The cause of a break can be

checked in [Cause of last break] of the [Status] window.

Refer to the [Watch] window for the value of variable i. The value is 4, indicating that the break occurred after

the condition had been satisfied five times.

Then delete the on-chip breakpoint. Clicking the right-hand mouse button on the [Event] window displays a

popup menu. Select [Delete All] from this menu to delete all the on-chip breakpoints.

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 242 243

Keine Kommentare

Renesas User System Interface Board HS7047ECH61H Bedienungsanleitung Seite 197