Renesas TM V.3.20A Spezifikationen PDF herunterladen (Seite 467)

100

101

Renesas Technology, Tools FAQs

Last Updated: February 20, 2003

Document Number: 03020501_e

If the target system is reset during the STEP execution, can the debugger continue to debug normally?

If the reset signal was "L" immediately before or during the STEP execution, the emulation pod may malfunction. Make sure the

reset signal is not set to "L" at these times.

To debug an operation involving a reset, perform the following procedure.

(1)Set a software break point at the start of the program.

(2)Execute RUN (program execution start) from the instruction where you want to confirm the reset sequence (see note 1).

(3)When the reset signal is "H", a breakpoint is initiated at the start of the program.

Note 1 :Do not set a software breakpoint at the instruction that you execute the RUN from.

When a RUN is executed from an instruction where a software breakpoint is set, the target system may malfunction in the

same manner as when the target system was reset during the STEP execution.

This occurs due according to the specifications for emulation pod control in order to execute the STEP from an instruction

where a software breakpoint is set and execute a normal RUN from the next instruction.

Top of Page | Back to Previous Page

1 2 ... 462 463 464 465 466 467 468 469 470 471 472 ... 761 762

Kommentare zu diesen Handbüchern

Keine Kommentare

Renesas TM V.3.20A Spezifikationen Seite 467

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Renesas TM V.3.20A