Renesas Technology, Tools FAQs
Last Updated: April 20, 2001
Document Number: 01051032_e
M32C/80, M16C/80 series M16C/60, 30, 20, 10 series 79xx series 77xx series 740 family
Q.
Can I connect my stand-alone PC with either Emulator PC4701U or PC4701HS using a LAN connection?
A.
There are two methods in which you can directly connect either PC4701U or PC4701HS to your PC:
10BASE-T Cross Connection
Use a commercially available 10BASE-T cross cable or a 10BASE-T cross converter to connect the PC4701U/ PC4701HS to
your PC to enable direct data transmission. For more details, please refer to MESC TOOL NEWS "Information on
Communications Using PD30, PD38, and PD77 " issued on June 16, 1998.
Connection example:
PC ---- cross converter cable ---- PC4701U/PC4701HS
1.
Stand-Alone Hub Connection
Just setup a stand-alone network hub that is isolated from your domain, and connect your PC and the PC4701U/PC4701HS
through the hub.
Connection Example:
Hub
| |
+---+ +---+
| |
PC PC4701U/PC4701HS
2.
How to setup the PC-to-PC4701U/PC4701HS connection:
When using either of the above connections, you will need to assign an IP address in the PC4701U or PC4701HS. Use the following
steps to setup the connection. For more details, refer to the instructions included with each product.
Connect the PC4701U/PC4701HS to your PC with an RS-232C cable, then boot-up the PDxx.1.
Set the IP address, sub-net mask, and port number for PC4701U/PC4701HS.
Make sure the assigned IP address is not the same as the PC's IP address (DHCP cannot be used).
❍
The sub-net mask value must be the same value as that of the PC.❍
The port number can be left as the default (4700).❍
2.
Shut down the PDxx and turn off PC4701U/PC4701HS.3.
Switch to the LAN, set the I/F switch to LAN, and then turn on the PC4701U/PC4701HS.4.
Boot-up the PDxx, then specify the IP address. This will let you connect to the emulator.5.
Top of Page | Back to Previous Page
Terms of Use Privacy Policy
(C)2004 Renesas Technology Corp., All Rights Reserved.
Kommentare zu diesen Handbüchern