Renesas SuperH SH7343 Technical Information PDF herunterladen (Seite 89)

Target interface (SH7705) Jun. 30, 2009 (Second Edition)

MDR connector

Signals

CPU Pin No. CPU Pin No. Pin

No.

Signal

Input/

Output

FP-208C TBP-208A

No.

Signal

Input/

Output

FP-208C TBP-208A

1 AUDCK Output 191 C7 2 GND

3 AUDATA0 Output 118 M15 4 GND

5 AUDATA1 Output 119 M16 6 GND

7 AUDATA2 Output 120 M17 8 GND

9 AUDATA3 Output 121 L14 10 GND

11 AUDSYNC Output 117 M14 12 GND

13 N.C. 14 GND

15 N.C. 16 GND

17 TCK Input 140 G14 18 GND

19 TMS Input 141 F17 20 GND

21 TRST Input 142 F16 22

GND

(

ASEMD0)

(Input) (145) (E17)

23 TDI Input 139 G15 24 GND

25 TDO Output 143 F15 26 GND

27 ASEBRKAK Output 144 F14 28 GND

29 VCC

Output 30 GND

31 RESETP Output 195 C6 32 GND

33 GND 34 GND

35 N.C. 36 GND

・ For the pin where stated as N.C. in the table, leave the signal unconnected.

*1: Input/output is based on the target system.

*2: To debug,

ASEMD0 pin needs to be brought to Low state.

Shown in the target connection reference diagram is the circuit that brings ASEMD0 pin to Low state when you connect ASEMD0 signal to the connector for

debugger.

If you do not connect ASEMD0 signal to Pin No. 22 of the connector for debugger, the circuit that sets ASEMD0 pin by switch circuit will do. However, in such

case, do not connect ASEMD0 pin to Pin No. 22 of the connector for debugger, but connect Pin No. 22 of connector for the debugger to GND.

*3: For VCC, connect I/O power of CPU. Debugging can be performed even if the signal is N.C., however, by connecting I/O power, leak during

the target system power OFF can be prevented.

Target connection reference diagram

MDR connector specifications

Recommended connector

Manufacturer 3M

Model 10236-52A2JL

(Top view on the target board)

(Side view on the target board)

(Pin Configuration)

(For detailed dimensions of the connector,

refer to the documentation by manufacturer of the connector.)

*Please look at the pin configuration diagram above and make

sure that the connector is in the right direction before connecting.

Please check the pin number in the signal table above and make sure

the signal and the pin numbers match.

*1:

RESETP, which is connected to Pin No. 31 of the connector for debugger, is the signal that debugger uses for monitoring the state of RESETP

pin of CPU.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 203 204

Kommentare zu diesen Handbüchern

Keine Kommentare

Renesas SuperH SH7343 Technical Information Seite 89

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Renesas SuperH SH7343