Renesas M3A-2152 Technical Information PDF herunterladen (Seite 42)

Software Setup

M3A-2114 User’s Manual (40/68)

6.2.3 Error Messages during M3S-KD32R Startup

If M3S-KD32R cannot communicate normally with the target system, it appears an error message in a pop-up box.

(1) Causes of errors on the SDI Interface Board side

If the error pop-up box shown in Figure 6.2-5 appears when starting M3S-KD32R, check whether power is

supplied to the M3A-2195 SDI Interface Board and whether it is firmly connected to the host PC with a cable

(LPT parallel cable).

Figure 6.2-5 Error Message at Startup (Error on M3A-2195 Side)

(2) Causes of errors on the M3A-2114 Evaluation Board

If the error pop-up box shown in Figure 6.2-6 appears when starting M3S-KD32R, check whether power is

supplied to the M3A-2114 Evaluation Board and whether it is firmly connected to M3A-2195 SDI Interface

Board.

Figure 6.2-6 Error Message at Startup (Error on the M3A-2114 Evaluation Board Side)

If the error pop-up box is appeared when starting M3S-KD32R, correct the cause of error and then click the OK

button in that pop-up box. This brings up the initialize window, allowing you to retry the startup. In this case, you

can retry only once.

6.2.4 Terminating M3S-KD32R

To terminate M3S-KD32R, choose [File] -> [Exit] from the pulldown menu. Then, a dialog box appears

prompting you for your confirmation (see Figure 6.2-7). Click the OK button in that dialog box to quit M3S-KD32R.

Or click the Cancel button, in which case M3S-KD32R does not terminate.

Figure 6.2-7 Dialog Box for Confirming Whether to Quit M3S-KD32R

Can’t connect with the target

ERROR(1705)

ERROR11473: Target MCU is not under control.

Please reset ta

et s

stems.

Cancel

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 69 70

Keine Kommentare

Renesas M3A-2152 Technical Information Seite 42