Renesas M3A-2152 Technical Information PDF herunterladen (Seite 38)

Software Setup

M3A-2114 User’s Manual (36/68)

6.1.3 Error Messages during M3T-PD32RM Startup

If M3T-PD32RM cannot communicate normally with the target system, it appears an error message in a pop-up

box.

(1) Causes of errors on the M3A-2114 Evaluation Board

If the error pop-up box shown in Figure 6.1-5 appears when starting M3T-PD32RM, check whether power is

supplied to the M3A-2114 Evaluation Board and whether it is firmly connected to M32100T-EZ-E.

Figure 6.1-5 Error Message at Startup (Error on the M3A-2114 Evaluation Board Side)

If the error pop-up box is appeared when starting M3T-PD32RM, correct the cause of error and then click the OK

button in that pop-up box. This brings up the initialize window, allowing you to retry the startup. In this case, you

can retry only once.

6.1.4 Terminating M3T-PD32RM

To terminate M3T-PD32RM, choose [File] -> [Exit] from the pulldown menu. Then, a dialog box appears

prompting you for your confirmation (see Figure 6.1-6). Click the OK button in that dialog box to quit M3T-PD32RM.

Or click the Cancel button, in which case M3T-PD32RM does not terminate.

Figure 6.1-6 Dialog Box for Confirming Whether to Quit M3T-PD32RM

ERROR11473: Target MCU is not under control.

Please reset tar

et s

stems.

Cancel

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 69 70

Keine Kommentare

Renesas M3A-2152 Technical Information Seite 38