Renesas M3A-2152 Technical Information PDF herunterladen (Seite 35)

Software Setup

M3A-2114 User’s Manual (33/68)

6.1.2 Starting M3T-PD32RM

Before starting M3T-PD32RM, make sure the hardware components have been set up in accordance with the

instructions in 5.1 Hardware Setup when M3A-2114G52A/ G62A/ G72A in use, and that the Starter Kit hardware

system (M3A-2114 Evaluation Board and M32100T-EZ-E) have been powered on.

Note: M3T-PD32RM cannot be started unless the power to the hardware system is turned on.

To start M3T-PD32RM, choose

[Start] -> [Programs] -> [RENESAS-TOOL] -> [PD32RM V2.10 Release 1] -> [PD32RM]

from Start menu of Windows. When M3T-PD32RM starts, the initialize dialog box shown in Figure 6.1-2 appears. So

initialize M3T-PD32RM from this dialog box.

Figure 6.1-2 M3T-PD32RM Initialize Dialog Box

(1) Setting MCU file

Click the MCU tab in the initialize dialog box (see Figure 6.1-2) and then the Refer button. This brings up a dialog

box for setting MCU files. In this dialog box, select the MCU file described below.

Table 6.1-1 MCU file

Group name MCU file name

32170 32170.mcu

32171 32171.mcu

32172 32172.mcu

32173 32173.mcu

32174 32174.mcu

This MCU file is stored in the directory: (installed location)\ PD32RM\ MCUFILES.

(2) Setting Model

While the MCU tab is open, select the appropriate MCU type from Model selection.

Cance Hel

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 69 70

Keine Kommentare

Renesas M3A-2152 Technical Information Seite 35