Renesas M3A-2152 Technical Information PDF herunterladen (Seite 40)

Software Setup

M3A-2114 User’s Manual (38/68)

6.2.2 Starting M3S-KD32R

Before starting M3S-KD32R, make sure the hardware components have been set up in accordance with the

instructions in 5.2 Hardware Setup when M3A-2114G52/ G62/ G72 in use, and that the Starter Kit hardware system

(M3A-2114 Evaluation Board and M3A-2195 SDI Interface Board) have been powered on.

Note: M3S-KD32R cannot be started unless the power to the hardware system is turned on.

To start M3S-KD32R,

choose [Start] -> [Programs] -> [RENESAS-TOOL] -> [KD32R V4.00 Release 1] -> [KD32R] from Start menu

of Windows. When M3S-KD32R starts, the initialize dialog box shown in Figure 6.2-2 appears. So initialize

M3S-KD32R from this dialog box.

Figure 6.2-2 M3S-KD32R Initialize Dialog Box

(1) Setting MCU file

Click the MCU tab in the initialize dialog box (see Figure 6.2-2) and then the Refer button. This brings up

a dialog box for setting MCU files. In this dialog box, select the MCU file described below.

Table 6.2-1 MCU file

Group name MCU file name

32170 32170.mcu

32171 32171.mcu

32172 32172.mcu

32173 32173.mcu

32174 32174.mcu

This MCU file is stored in the directory: (installed location) \ KD32R\ MCUFILES.

(2) Setting Model

While the MCU tab is open, select the appropriate MCU type from Model selection.

(3) Setting Mode

While the MCU tab is open, select the appropriate MCU operation mode from Mode selection.

Cance Hel

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 69 70

Keine Kommentare

Renesas M3A-2152 Technical Information Seite 40