Renesas SuperH SH7600 Series Technical Information PDF herunterladen (Seite 8)

1.2 Connecting the E10A Emulator with the User System

To connect the E10A emulator (hereinafter referred to as the emulator), the H-UDI port connector

must be installed on the user system to connect the user system interface cable. When designing

the user system, refer to the recommended circuit between the H-UDI port connector and the

MCU. In addition, read the E10A emulator user's manual and hardware manual for the related

device.

Table 1.2 shows the type number of the E10A emulator and the corresponding connector type.

Table 1.2 Type Number and Connector Type

Type Number Connector

HS7618KCM01H, HS7618KCI01H 14-pin connector

1.3 Installing the H-UDI Port Connector on the User System

Table 1.3 shows the recommended H-UDI port connectors for the emulator.

Table 1.3 Recommended H-UDI Port Connectors

Connector Type Number Manufacturer Specifications

14-pin connector 2514-6002 Minnesota Mining &

Manufacturing Ltd.

14-pin straight type

Note: Do not install any components within 3 mm of the H-UDI port connector.

1.4 Pin Assignments of the H-UDI Port Connector

Figure 1.1 shows the pin assignments of the H-UDI port connector.

Note: Note that the pin number assignments of the H-UDI port connector shown below differ

from those of the connector manufacturer.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Keine Kommentare

Renesas SuperH SH7600 Series Technical Information Seite 8