Renesas M3T-SRA74 Bedienungsanleitung PDF herunterladen (Seite 42)

E8a Emulator User's Manual 3. Preparation before Use

3.6 Connecting the Emulator to the User System

Use the procedure below to connect the emulator to the user system with the user system interface

cable, or to disconnect them when moving the emulator or the user system.

1. Check that the host computer is turned off or the emulator is not connected to the host

computer with the USB cable.

2. Connect the user system interface cable to the user-side connector of the emulator.

3. Connect the USB cable to the host-computer-side connector of the emulator.

(1) The connector must be installed on the user system. Table 3.2 shows the recommended

connector for the emulator.

Table 3.2 Recommended Connector

Type Number Manufacturer Specifications

2514-6002 3M Limited 14-pin straight type

Note: When the connector is installed on the user system, do not install any components within 3

mm of the connector.

REJ10J1655-0400 Rev.4.00 Page 26 of 158

Apr 30, 2010

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 176 177

Keine Kommentare

Renesas M3T-SRA74 Bedienungsanleitung Seite 42