Renesas M16C/6N Bedienungsanleitung PDF herunterladen (Seite 9)

QDK™

M16C/Neutrino-NC30

www.state-machine.com/m16c

1. Connect the E8 debugger to the NEUTRINO board with the provided ribbon cable as described

in the Quick Start Guide.

2. Connect the E8 debugger to the PC with the provided USB cable as described in the Quick Start

Guide.

3. Launch HEW IDE and open the project

pelican-neutrino.hws

(located in

<qp>\examples\m16c\-

vanilla\nc30\dpp_neutrino\

). Figure 2 shows the screen shot of the HEW IDE after opening the

project.

4. Build the project by select Build->Build menu or by pressing F7.

2.4 Running the Examples

The HEW debugger can directly communicate with the E8 In-Circuit Debugger (see Figure 1). To

load the code into the MCU’s flash, select Debug|Download Modules menu (see

Figure 2). This will

launch the progress-bar message box. When the message box window goes away, the MCU is pro-

grammed. You can run the example by selecting menu Debug|Go (see

Figure 3).

Figure 3 HEW Debugger with various views of the executing DPP application.

7 of 25

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Keine Kommentare

Renesas M16C/6N Bedienungsanleitung Seite 9