Renesas HS2378KCI01H Bedienungsanleitung PDF herunterladen (Seite 8)

1.2 Connecting the E10A Emulator with the User System

Before connecting an E10A emulator with the user system, a connector must be installed in the

user system so that an user system interface cable can be connected. When designing the user

system, refer to the connector and recommended circuits shown in this manual.

Before designing the user system, be sure to read the E10A emulator user’s manual and the

hardware manual for related MCUs.

Connect pins 8, 9, 10, 12, 13, and 14 of the user system connector to GND firmly on the PCB.

These pins are used as electrical GND and to monitor the connection of the user system connector.

Note the pin arrangement of the user system connector.

User system interface cable

User system connector

User system GND

connection

User system

GND line

Tab

Pin 1

Pin 8

Figure 1.1 Connecting the User System Interface Cable to the User System

Notes: 1. The pin number assignment of the 14-pin connector differs from that of the E10T

emulator; however, the physical location is the same.

2. When the connector is used, do not install any components within 3 mm of the

connector.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Keine Kommentare

Renesas HS2378KCI01H Bedienungsanleitung Seite 8