Renesas Emulator System E8 Betriebsanweisung PDF herunterladen (Seite 18)

CSE8E10-2

Connecting to the target board, E8/E8a

IAR C-SPY® Hardware Debugger Systems

User Guide

5 If the Firmware Location & WDT dialog box is displayed, you must confirm the

placement of code and data on the target microcontroller. If your application uses a

watchdog timer, select the Debugging of program that uses WDT option to cause the

watchdog timer to be refreshed when your application is running.

If you use the default device-specific XLINK linker command file, you do not need to

change any settings.

Debugging of CPU rewrite

mode

Erases the flash memory data for the MCUs and simultaneously

writes the E8/E8a emulator program, when starting the debug-

ger. Select this setting when debugging the program which

rewrites the CPU.

Note: In this mode, it is not possible to set PC breakpoints or

to change the contents of the flash memory.

Execute the user program

after ending the debugger

Executes your application when you stop the debugger. This

option requires external power supply.

Note: This option is available only for the E8a emulator and

only when Program Flash has been selected.

Power target from Emula-

tor

Select this option if the target board is not connected to any

power supply.

Do not show this dialog box

again

If you select this option, the dialog box will not be displayed the

next time the debugger is launched. This option is mirrored in

the E8/E8a Emulator menu command Show Emulator Set-

ting. Use the menu command to display the dialog box again.

See also Maintaining the connection to the hardware, page 8.

E8/E8a Emulator option Description

Table 4: The E8/E8a emulator mode options (Continued)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 40 41

Keine Kommentare

Renesas Emulator System E8 Betriebsanweisung Seite 18