Renesas Emulator System E8 Betriebsanweisung PDF herunterladen (Seite 15)

CSE8E10-2

Introduction to C-SPY® hardware debugger systems

The C-SPY emulator driver communicates with the emulator via the USB driver. The

emulator communicates with the emulator interface on the microcontroller.

Figure 1: Emulator communication overview

For further information, refer to the Renesas documentation supplied with the emulator.

When a debugging session is started, your application is automatically downloaded and

programmed into flash memory.

Programming the E10A-USB firmware

Before an E10A-USB emulator can be used for the first time, the emulator firmware

must be programmed. To program or update the firmware, follow these steps:

1 Make sure the USB cable is not attached to the emulator. Then open the sliding switch

cover and make sure that the mode selection switch (number 1) is set to 1.

Note: The USB cable must never be attached when you change the mode selection

switch.

C-SPY emulator driver

Host computer

C-SPY

Debugger

USB driver

Emulator

CPU

FLASH RAM

Target board

USB connection

Flat cable

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 40 41

Keine Kommentare

Renesas Emulator System E8 Betriebsanweisung Seite 15