Renesas FLASH Development Toolkit 3.07 Bedienungsanleitung PDF herunterladen (Seite 21)

FDT toolbar

Figure 2-7 FDT Toolbar

Connect - connects the device to the interface.

Disconnect - disconnects the device from the interface.

Erase Blocks - launches the ‘Erase Block’ dialog box to erase all or individual blocks of the device FLASH

memory.

Blank Check - checks whether or not the FLASH section of the target device is blank.

Upload - launches the ‘Upload Image’ dialog box to allow data to be obtained from the target device.

Download Active File - downloads the file which is active in the hex editor.

Checksum – returns a checksum of the data in the FLASH.

Go from Address – launches a dialog to select the address to execute from.

Cancel – Cancels the current FLASH operation.

Configure Flash Project - launches the ‘Project Properties’ dialog box (or the Project Wizard if the project

is not yet configured).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 145 146

Keine Kommentare

Renesas FLASH Development Toolkit 3.07 Bedienungsanleitung Seite 21