Renesas FLASH Development Toolkit 3.07 Bedienungsanleitung PDF herunterladen (Seite 136)

122

15.2 Connection

If FDT is connecting to a device that supports the locking feature it will check the current locked state of

each erase block that has a corresponding lock bit (as defined in the project configuration file). Then,

depending on the current connection setting (selectable from the Locking Dialog - see section 15.3), FDT

will do one of three things:

1. Automatically Disable Locks

FDT will automatically disable the locking of device on connection. This will allow all blocks on the

device to be written or erased - whether they are currently locked or not.

2. Query User

FDT will ask the user what to do about the locking of device on connection:

Figure 15-3 Query on Connection Message

If "Yes" is clicked, then the master lock bit will be disabled, as in (1). If "No" is selected then the locking

settings will be left alone, as below.

3. Do Nothing

FDT will not change any of the current lock settings on the device. Subsequently, FDT will abort the

operation if an attempt is made to write or erase to a locked block.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 145 146

Keine Kommentare

Renesas FLASH Development Toolkit 3.07 Bedienungsanleitung Seite 136