Renesas Emulator System SH7362 Bedienungsanleitung PDF herunterladen (Seite 117)

E8a Emulator User's Manual 11. Appendix E: E8aSCP (E8a Self-Check Program)

R20UT0541EJ0601 Rev.6.01 Page 117 of 124

Aug 25, 2011

WARNING

Warnings for Connecting to the Self-Check Connector:

 Make sure to disconnect the USB cable from the E8a before connecting the user system

interface cable to the user-system connector or the self-check connector of the E8a.

If the E8aSCP program is executed when the USB cable remains connected to the E8a after

‘Disconnect’ is done from the High-performance Embedded Workshop or Flash Development

Toolkit, self-checking will not be executed correctly. This is caused by the different condition of

the E8a pins. The E8aSCP program expects that the E8a pins are in the condition right after

starting-up the E8a, but after ‘Disconnect’ is done, they remain in the condition where the E8a is

connected to the user system.

 Fully insert the user system interface cable in the self-check connector as shown in Figure E.2.

(3) Start up the host computer, and connect the E8a emulator to the USB connector of the host computer via the USB

cable provided.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 123 124

Keine Kommentare

Renesas Emulator System SH7362 Bedienungsanleitung Seite 117