Renesas H8SX Bedienungsanleitung PDF herunterladen (Seite 22)

The Flash Development Toolkit (FDT) is supplied to allow programs to be loaded directly on to the board using this method. Please select

USB Direct interface while downloading the program.

8.4.Serial Port Programming

This sequence is not required when debugging using the E8 supplied with the kit.

The microcontroller must enter boot mode for programming, and the programming port must be connected to a host for program download.

To execute the boot transition, and allow programs to download to the microcontroller, the user must perform the following procedure:

Fit a jumper link in position J16 or fit R133.

Perform the link changes described in section

6.4 to enable serial debug.

Connect a 1:1 serial cable between the host PC and the CPU board J8.

Depress the BOOT switch and keep this held down.

Depress the RESET switch once, and release.

Release the BOOT switch. The BOOT LED will be illuminated.

The Flash Development Toolkit (FDT) is supplied to allow programs to be loaded directly on to the board using this method.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 36 37

Keine Kommentare

Renesas H8SX Bedienungsanleitung Seite 22