Renesas M3T-ICC740 Technical Information PDF herunterladen (Seite 48)

9. Debugging a Project

For the project you’ve finished building, an absolute file proj_1.695 is generated in the

working directory.

This file can be debugged in the M3T-PD38 or M3T-PD38SIM. In the TM, you can use

the Debug button in the project bar to invoke the debugger (Figure 31).

Figure

Figure Figure

Figure 31

3131

Debug button in the Project Bar

Debug button in the Project BarDebug button in the Project Bar

Debug button in the Project Bar

The debugger invoked this way is the one that you registered to the TM.

If there are no registered debuggers, the Tool Information dialog box will be displayed. So

Figure 32).

Figure

Figure Figure

Figure 32

3232

DEBUG TOOL tab of the Tool Information dialog box

DEBUG TOOL tab of the Tool Information dialog boxDEBUG TOOL tab of the Tool Information dialog box

DEBUG TOOL tab of the Tool Information dialog box

In the TM, furthermore, if the M3T-PD38 or M3T-PD38SIM was already installed before

you installed the TW74, the installed debuggers are automatically listed (Figure 32 (b)). If

you installed the M3T-PD38 or M3T-PD38SIM after installing the TW74, no debuggers are

listed. In this case, the installed debuggers are automatically listed when you reinstall the

TW74.

To register one of the listed debuggers, select its check box (marked by a check mark when

selected).

Other debug tools are not automatically listed. Therefore, use the Add button to register any

debug tool you want.

Debug Button

(a) With no debugger list (b) With a debugger list

dd button

1 2 ... 43 44 45 46 47 48 49 50 51 52 53

Keine Kommentare

Renesas M3T-ICC740 Technical Information Seite 48