Renesas HS6400FDIW3S Bedienungsanleitung PDF herunterladen (Seite 77)

Readback Verification

After programming, FDT can verify the data was programmed successfully by performing a

read-back verification. Use this option to specify whether you would like to perform read-

back verification, always, after confirmation, or never. Double click to edit the setting.

Reset on Disconnect

When disconnecting from the device when used in combination with a UPB or FDM, FDT

can be used to reset the target hardware. Use this option to specify whether you would like to

reset the device, always, after confirmation, or never. Double click to edit the setting.

Connection Reset

This option controls whether FDT should set the mode pins and apply a reset when

connecting in User Mode with the FDM. The options are:

Default – Uses the default settings (Set Reset & Mode Pins). This is held in a registry setting.

Reset & Mode – Apply the Reset and set the Mode Pins

Mode Only – Suppress applying the Reset but set the Mode pins. Note that care must be

taken to ensure that this will not damage the device or cause unpredictable behaviour. This

option is mainly for making the transition between User Mode and User Program Mode

None – Suppresses applying the Reset and setting the Mode pins.

Reinterrogate on Disconnect

This option forces FDT to reinterrogate Generic Boot devices on connection. With this option

set to "No" (default), the device settings are saved in an automatically generated fcf file and

re-used. With this option set to "Yes", FDT will always reinterrogate the device for its

details upon connection; this allows one project to work with many Generic Boot devices. If

this option is set to "Query", FDT will ask you to select whether to reinterrogate the device.

Double click to edit the setting.

Function Map

This section is for Protocol A (Legacy) kernels only.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 93 94

Keine Kommentare

Renesas HS6400FDIW3S Bedienungsanleitung Seite 77