Renesas Single-Chip Microcomputer SH7203 Technical Information PDF herunterladen (Seite 11)

5.2. Connecting the debugger

For this tutorial connect an external power supply to the board, taking care to ensure the correct polarity and voltage.

The Quick Start Guide provided with the RSK board gives detailed instructions on how to connect the E10A to the host computer. The

following assumes that the steps in the Quick Start Guide have been followed and the E10A drivers have been installed.

• Connect the E10A debugger to the USB port on your computer.

• Connect the E10A Debugger to the target hardware ensuring that it is plugged into the connector marked E10A

• Turn on the external power supply to the board.

5.3. Connecting to the target

This section will take you through the process of connecting to the device, programming the Flash and executing the code.

• Click the connect button from the Tool Bar.

• On ‘Select ‘Emulator mode’ dialog

For

Device select ‘SH7203’

For Mode select ‘E10A_USB Emulator’

• Click <OK>

• Press the RES button on the RSK board.

• Click <OK>

• The system should then connect.

• Click Emulator System from Tool bar.

• Switch to the ‘Loading flash memory’ Tab

Note: Please ensure all settings for both tabs of the

‘Configuration Dialog’ match the diagrams shown.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Keine Kommentare

Renesas Single-Chip Microcomputer SH7203 Technical Information Seite 11