Renesas H8SX/1582 Bedienungsanleitung

To our customers, Old Company Name in Catalogs and Other Documents On April 1st, 2010, NEC Electronics Corporation merged with Renesas Technology C

Chapter 5. Building the Tutorial Project The tutorial project build settings have been pre-configured in the tool-chain options. To view the tool ch

The Quick Start Guide provided with the RSK board gives detailed instructions on how to connect the E8 to the host computer. The following assumes th

• Select E8DIRECT as the communication Port • Press <Next>. • The default settings are suitable for an un-modified RSK board. • Confirm t

• Confirm the default selections of ‘Automatic’ and ‘Advanced’. • Press <Next>. • The following warning dialog will be displayed. • Press

Damage to the microcontroller can be sustained with incorrect settings. • Confirm the mode pin settings. • Press <Finish>. The Flash configu

A further dialog will be displayed to confirm if it acceptable to assume only one E8 device will be connected to the host computer while using this p

Chapter 6.Downloading and Running the Tutorial Once the code has been built in HEW it needs to be downloaded to the RSK. Now that you are connected t

We will now skip over the initialisation code and proceed to the main tutorial. • Open the file called ‘resetprg.c’ by double clicking it in the pr

The code window will open ‘main.c’ and show the new position of the program counter. Support for the LCD display is included in the tutorial code. W

The code will run and flash the LEDs 200 times. The debugger will not stop running until all 200 flashes have completed or a button is pressed on the

Notice 1. All information included in this document is current as of the date this document is issued. Such information, however, is subject to chang

• Open the file ‘main.c’ • Insert a breakpoint on ‘StaticsTest();’. The statics test is used to demonstrate that the initialisation has successfull

Chapter 7.Project Files 7.1.Standard Project Files The RSK tutorials are configured so that it is possible to provide the same tutorial code on multi

7.1.2.Board initialisation code (Hwsetup.c / hwsetup.h) There are four common stages to the configuration of the microcontroller device. The code to

7.1.3.Main tutorial code (Main.c / main.h) The main tutorial code is common to all tutorial projects. The display initialisation and string display f

Chapter 8.Additional Information For details on how to use High-performance Embedded Workshop (HEW), refer to the HEW User manual available on the CD

Renesas Starter Kit for H8SX1582 Tutorial Manual Publication Date Rev.2.00 15.JAN.2007 Published by: Renesas Tec

1753, Shimonumabe, Nakahara-ku, Kawasaki-shi, Kanagawa 211-8668 JapanRenesas Starter KitREG10J0002-0200RSK H8SX1582 Tutorial Manual

Renesas Starter KitRSK H8SX1582 Tutorial ManualUser’s ManualRev.2.00 2007.01RENESAS SINGLE-CHIP MICROCOMPUTER

Table of Contents Chapter 1. Preface...

Chapter 1. Preface Cautions This document may be, wholly or partially, subject to change without notice. All rights reserved. No one is permitted t

Chapter 2.Introduction This manual is designed to answer, in tutorial form, the most common questions asked about using a Renesas Starter Kit (RSK):

Chapter 3.Tutorial Project Workspace The workspace includes all of the files for two build configurations. The tutorial code is common to both the De

Chapter 4. Project Workspace 4.1.Introduction HEW is an integrated development tool that allows the user to write, compile, program and debug a soft

• The project name field will be pre-filled to match the workspace name above; this name may be changed. Note: HEW allows you to add multiple projec