Renesas Emulator System SH7362 Technical Information PDF herunterladen (Seite 11)

1.3 Installing the H-UDI Port Connector on the User System

Table 1.3 shows the recommended H-UDI port connectors for the emulator.

Table 1.3 Recommended H-UDI Port Connectors

Connector Type Number Manufacturer Specifications

DX10M-36S Screw type

36-pin connector

DX10M-36SE,

DX10G1M-36SE

Hirose Electric Co., Ltd.

Lock-pin type

14-pin connector 2514-6002 Minnesota Mining &

Manufacturing Ltd.

14-pin straight type

38-pin connector 2-5767004-2 Tyco Electronics AMP K.K. 38-pin Mictor type

Note: When designing the 36-pin connector layout on the user board, do not connect any

components under the H-UDI connector. When designing the 14-pin connector layout on

the user board, do not place any components within 3 mm of the H-UDI port connector.

When designing the 38-pin connector layout on the user board, reduce cross-talk noise etc.

by keeping other signal lines out of the region where the H-UDI port connector is situated.

As shown in figure 1.1, an upper limit (5 mm) applies to the heights of components

mounted around the user system connector.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 65 66

Keine Kommentare

Renesas Emulator System SH7362 Technical Information Seite 11