Renesas Emulator Debugger M16C PC4701 Bedienungsanleitung PDF herunterladen (Seite 11)

( 11 / 52 )

Note on RESET* Input:

• The reset input from the target system is accepted only while a user program is being executed (only

while the RUN status LED on the PC4701's front panel is lit).

IMPORTANT

Note on When Starting Up the Emulator Debugger:

• With the M30100T-RPD-E, it is necessary to execute the following when starting up the emulator

debugger. Otherwise, the M30100T-RPD-E may not operate properly.

Custom command

Execute custom command RESET_10 every time you start up the emulator debugger.

• When you execute custom command RESET_10, if "RESET_10 is done!" is displayed instead of

"RESET_10 (Ver.2) is done!", a custom command program file of a previous version is used.

Replace the old custom command program file reset_10.p with the "reset_10.p" file in the floppy

disc included with this product, and re-execute custom command RESET_10.

Note on Clock Supply to the MCU:

• Clock can be supplied to the evaluation MCU in one of the following two ways. This is determined

by emulator debugger clock selection.

(1) When Internal is selected:

The clock generated by the oscillation circuit in the emulation pod is supplied to the evaluation

MCU. The clock is continually supplied to the evaluation MCU regardless of "target system

clock status" and "user program execution status".

(2) When External is selected:

Clock supply to the evaluation MCU depends on oscillation status (oscillate/off) of the target

system.

• It is necessary to use an oscillation circuit board with this product.

Notes on MAP References and Settings:

• For details on referencing and setting MAP information, see the user's manual of emulator

debugger M3T-PD30.

• The initial map settings of this product are as shown below. Use this product with the initial settings.

00000h--003FFh: "EXT"

00400h--FFFFFh: "INT"

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Keine Kommentare

Renesas Emulator Debugger M16C PC4701 Bedienungsanleitung Seite 11