Renesas R0E572110CFK00 Technical Information PDF herunterladen (Seite 30)

2.7 Connecting the E200F External Bus Trace Unit with the User System

To use the external bus trace function in the emulator, the emulator and the user system must be

connected via the external bus trace unit (R0E0200F1ETU00). Install the connector on the user

system for connection of the external bus trace unit, referring to section 2.8, Installing the External

Bus Trace Unit Connector, in this manual. When designing the user system, read the SH-2A, SH-2

E200F Emulator User's Manual and hardware manual for the related MCU.

2.8 Installing the External Bus Trace Unit Connector

2.8.1 External Bus Trace Unit Connector Installed on the User System

Table 2.3 shows the recommended external bus trace unit connector.

Table 2.3 Recommended Connector

Type Number Manufacturer Specification

QTH-090-04-L-D-A Samtec, Inc. QTH series, 0.5-mm pitch, 180 pins

Note: Do not place any components within 6 mm of the external bus trace unit connector.

2.8.2 Pin Assignments of the User System Connector

Pin assignment on the user system (connector is installed)

Probe direction

179

180

Figure 2.12 Pin Assignments of the User System Connector

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 91 92

Keine Kommentare

Renesas R0E572110CFK00 Technical Information Seite 30