Renesas Single-Chip Microcomputer M306NKT3 Bedienungsanleitung PDF herunterladen (Seite 131)

115

11.1.4 Request Checksum

This option controls whether FDT automatically performs a checksum request operation after

programming. The setting is remembered between sessions.

11.1.5 Erase Device Before Program

This option controls whether FDT automatically performs an erase operation before programming the

device. This will erase all blocks in all memory areas prior to programming. The setting is remembered

between sessions.

11.1.6 Security Protection

This option controls whether FDT should security protect QzROM devices as it disconnects. Select

“Automatic” to always protect the device at disconnection. Select “Prompt” to query the user what to

do and select “None” to never protect the device at disconnect. NB – a protected device cannot be

reconnected to.

11.1.7 Field Programming->Run Published File…

Unpackage another .fpf file and use it in Simple Interface Mode.

11.1.8 About…

Shows the About box.

11.2 Dialog Controls

11.2.1 Back to Project

This returns to the full FDT Workspace view. This will be disabled if the user currently logged in to

FDT does not have the ‘FDT:Project Edit’ access. [see Chapter 5 for details]

11.2.2 Exit

Clicking this will exit FDT and FDT will start up in the Simple Interface Mode next time it is loaded.

This will be disabled if the user currently logged in to FDT does not have the ‘SimpleInterface:Exit’

access. [see Chapter 5 for details]

11.2.3 Download Project image radio button

This will be disabled if the user currently logged in to FDT does not have the

SimpleInterface:Download Project Image’ access. [see Chapter 5 for details]

11.2.4 Program Flash

Clicking on Program Flash allows FDT to download the specified file or image to the FLASH

memory. Additionally, if Readback Verify is switched off, the Checksum will also be calculated and

output to the screen.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 146 147

Keine Kommentare

Renesas Single-Chip Microcomputer M306NKT3 Bedienungsanleitung Seite 131